GE Dishwasher Error Codes
What GE dishwasher error codes mean and what a technician checks for each one. Need it fixed? GE dishwasher repair in Charlotte.
GE / Profile / Café electronic dishwashers
| Code | Meaning | What to check |
|---|---|---|
| 1H...24H | Delay Start active (info) | Not a fault - delay start countdown. |
| C1 | Pump-out ran over 2 min | Clean air gap, fix/reposition drain hose, run disposer. |
| C2 | Total pump-out >7 min | Press Reset; check drain path. |
| C3 | Machine won't drain | Breaker off 30 s, reset; then service. |
| C4 | Filled twice after power failure (stuck float / clogged sump) | Tap float cover; clear sump debris. |
| C5 | Pump-out time too short | Water supply on; free the float. |
| C6 | Incoming water too cold | Run hot faucet first; raise water heater temp. |
| C7 | Water temperature sensor circuit inoperative | Breaker reset; then service (thermistor/harness). |
| C8 | Detergent cup blocked | Remove obstruction; close door, wait 30 s. |
| PF | Power failure occurred | Select cycle and press Start. |
| Cup Open | Detergent cup not closed | Close cup; Start again overrides. |
| FTD / F56 | Failure to drain | Drain hose, air gap, disposer knockout plug, filter, drain pump. |
| LEAK DETECTED | Possible leak - cycle cancelled | Service: find the leak, check base pan and leak sensor. |
| 999 | Floor Protect models: leak detected. Others: control needs reset | Floor Protect: service. Other: reset control. |
| H2O | Low water | Inlet hose kinks, water valve open; in 1-Hour Wash - schedule service. |
| PrS | Pressure sensor invalid signal | Harness or pressure sensor - service. |